Network Computing Devices 9300572 Rev. B Manual do Utilizador descarregar pdf (Página 16)

Installing NCDware on WinCenter Systems

The procedure in this section is required for NT-only networks. If

your

NCD network computers (also called terminals) are on an

NT-only network, you need to install NCDware on a WinCenter

server so it can act as a boot server for the

NCD terminals.

The instructions below describe how to install

NCDware on a

WinCenter server running WinFrame 1.6 or later. For information

about WinCenter, see WinCenter product documentation. For

additional information about using and configuring

NCDware, see

NCDware documentation.

Using

setup

To install NCDware you need:

❏ A WinCenter server equipped with a CD-ROM drive and running

WinFrame 1.6 or later

❏ Approximately 10 minutes for the installation

Note For information on space requirements, see the Release

Notes or the ﬁle

SIZES on the CD-ROM.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23

Sem comentários

Network Computing Devices 9300572 Rev. B Manual do Utilizador Página 16