
Advanced Users Configuration Notes
NCD ThinSTAR 300 User’s Guide A-7
Note Your system administrator may have set a
password in order to prevent you from
making changesto Terminal Properties.In
that case, the OK and Apply buttons are
grayed out (non-active), until you enter
the password through the Terminal
Properties > Management tab > Security...
panel.
If no password has been set, the OK and
Apply buttons are enabled and you can
make your changes without entering a
password.
Table A-2 Terminal Properties Tasks
Task Action
Displaying the
NCD Terminal
Properties panel
Press CTRL+ALT+END, (displays the
NCD ThinSTAR Connection Manager),
then press F2.
Making changes
to Terminal
Properties
❏ Click Apply to apply changes
without closing the panel
❏ Click OK to apply changes and close
the panel
❏ Click Cancel to close the panel
without applying changes
Making changes
to Terminal
Properties when
password
protected
You must enter the password each time
you make a change. Go to the
Management tab Security panel, enter
the password and click OK. The Apply
and OK buttons are enabled and you can
make your changes.
Modifying
mouse right or
left handedness
Do not use Terminal Properties. Make
these adjustments on the Terminal Server
through Start > Settings >
Control Panel > Mouse
.
Comentários a estes Manuais